ONTAP MetroCluster FC Installation 9.8

• NetApp Employees
• Partner Professional Service Implementation Engineers
• Customers

This course focuses on enabling you to do the following:

• Describe the major architectural components of a MetroCluster environment
• Cable nodes, back-end FC switches, and FibreBridge devices
• Set up bridges and back-end FC switches
• Configure the clusters at both sites in a MetroCluster environment
• Set up a MetroCluster configuration and serve data to clients
• Detect and recover from failures in a MetroCluster environment
• Install and configure NetApp MetroCluster TieBreaker software

• Basic SAN knowledge
• Completion of an ONTAP Professional Compliance Program or equivalent

Module 1: Overview of MetroCluster

Introduction to MetroCluster software
Supported configurations
Implementation steps
Configuration tools and documentation

Module 2: MetroCluster Cabling

Disk requirements
Cabling overview
Controller cabling
Switch cabling

Module 3: Bridge and Switch Configuration

ATTO FibreBridge configuration
Brocade FC switch configuration
IOD and OOD delivery

Module 4: Cluster Configuration

Disk assignment
Cluster setup

Module 5: MetroCluster Configuration

Setup
Verification
Monitoring
SVM configuration

Module 6: Failure Scenarios

Switchover
Switchback
Failure scenarios
LIF placement

Module 7: TieBreaker Configuration

Introduction to TieBreaker
Installation
Configuration